I’m working on a project that requires the use of two interface devices; a button and a potentiometer, but I wanted the look of the enclosure to be really clean. I was thinking about where to place the button and potentiometer, which is when I realized, it wouldn’t be too hard to make a potentiometer that could be pushed for the select function. Within an hour I had this little prototype put together. There are a few areas that need improvement, but overall, it works great! For materials, I used a spring, pot, tactile switch, and a couple of screws/bolts to hold it all together. It’s really simple to put together so I’ll let the pictures do the explaining. Feel free to post any questions in the comments section.